My cart:
0
Your cart is currently empty.
Creative Ceramics Moulds for Fusing, Slumping & Casting
To stop the glass from running off the mould during the firing, block the ends of the mould with ceramic fibre paper or similar.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
Specific References
7400 1.630000
Related Products (There are 16 other products in the same category)
